Ah... the usual bulging capacitor on the display board! It shouldn't be related to the hum but ideally should be replaced.

As it is almost impossible to get to the underside of the board (unless you fancy de-soldering the delicate vacuum display), I would leave the display in place, carefully cut the faulty capacitor off the board, de-solder the legs, and then insert a replacement capacitor slightly proud of the PCB (so you have enough room to solder the legs on the component side).

If you need to remove the display, there is a nut and washer behind the volume knob that needs to be undone. Be careful as it is also glued via a sticky pad to the front glass!

Good luck,

Steve


Main: 861v6 (LPS), 808v6, UHD722, DSP8000SE Anniversaries, DSP5200.2HC, DSP7200.2, SW1600, Sky Q, Cambridge Audio BD, Roon, M80
Office: 861v4 (LPS), 818v3, 800v4, HD621, M&K S150P, DSP5500HC, M&K MPS2810 sub x2
Son's system: 861v4, HD621, DSP6000.2, DSP5200HC, DSP33
Spare: MCD, 100 Series, 200 Series, 500 Series, F80s, C15s.