I took mine apart again. Cleaned everything again and used some contact chemie protector after cleaning.

Calibration mode worked with the minimum of cards as described in TN32.

The next card of the list was the analog in. No sound but changing the DSP mode for tape went very slow and the G68 froze for a long time. Removed it, restart and continued with digital in card. Bingo sound tru digital out.

Continued with the other boards and it kept working. Added the analog in board and it kept working only without the analog in function, so have to look in to that.

I made the mistake to try to turn it on during the powering up (the display shows Meridian before going to standby) which shuts down the startup process and the G68 did not work.

Removing that card and startup again, turned it off again, inserted the card and waited until the G68 went in standby mode and the card was aded to the system and the G68 worked again.

For now fingers crossed that it keeps working. I’m going to change the capacitors on the analog in board to see if that helps.

Perhaps this info helps the ts.

Last edited by Rick7; 2024-06-30 07:20.
Some Meridian...