I remove and cleaned ALL the PCB, then I started to test the product without the zone 2/3, tuner and input boards. Always the same scenario, no sound in the digital outputs.

I measured the voltage in all boards and they all read about 5.05 volts and 3.33 volts.

The volume button still are not responsive.

Is there a right slot for every board or can I try the FICL and DSP board in another placement?

I was also in doubt it they are in the right place right now, but I found no picture of the output side of the processor showing the boards proper placement.

Any ideas?

Best Regards,

Jorge