Meridian Unplugged - Powered by MrTechGuy.co.uk Forums Discussion Meridian - Systems SpeakerLink pin layout

I have now seen posts on this on this forum confirming that the M6 will power the MS200.(edited from MC200 - thanks for the correction Bruce!)

My diagram of an impedance matching transformer in my previous post above was a non specific make.

Looking at a Canare (may not be your exact model) in more detail , I have noticed that the ground is connected to the centre tap of the transformer meaning that the phantom power is connected across half of the transformer winding:



The Neutrik one does not have the ground connected to a centre tap on the AES side of the transformer:



I think that I have seen a forum member use one of these Neutrik ones before - I'm not shure which direction or whether there was phantom power.

There are 4 types (with various different sex connectors). I suspect that they can all be used in either direction but the data sheets suggest that 2 have a 75 ohm input - although its not marked as input on the device. (The 3rd one down should be OK)



Peter