Hello Everyone,
I have a 561. I believe it does not have the Tape module installed, because there is no headphone jack.
I have the Room 2 outputs going to a Stereo Receiver in another room. I know how you use the copy feature to select the sources, and how to use the copy mute feature. But I can't fine anywhere in the manual that says how to adjust the output of the Room 2 signal. I realize it is a line level output, but is there any way to adjust its output? I now need to set the Volume on my second room receiver higher than I had to when I had a different preamp (A Kenwood KC-105) sending the signal to it.
I know the 561 lets you adjust the sensitivity of the Analog inputs. Is there any such feature for the Room 2 outputs?
Thanks in advance!
Dan
Theater: 565/562v, 519, Analog speakers (NHT & Velodyne) Pioneer LaserDisc, Sony PS3, Comcast Cable Office: 561, DSP5000.2, NHT rears, Acurus Amp, Technics Turntable, Sony SACD Changer, PC Digital out
|