Hualon,

As bxd pointed out, the 568.2MM is only capable of 6 discrete channels (5.1) and the sides are matrixed to feed 8 speakers in a simulated 7.1 setup.

I have a 568.2MM connected to both a 598 and a HD621 via a mechanical component switcher to choose the source. No problem with sound but I have my rears fed into the 568.2MM from the 7/8 digital out on the HD621.

There has been a lot of discussion on this in the past 5/6 versus 7/8 but Meridian has finally confirmed this in writing, see point 18 in the UHD722 topic.
Quote
18. MY MERIDIAN SURROUND CONTROLLER HAS A MULTI-CHANNEL DIGITAL INPUT IN THE FORM OF THREE PHONO (RCA) SOCKETS BUT NOT THE RJ45 TYPE OF SOCKET USED ON NEWER PRODUCTS. HOW DO I CONFIGURE AND CONNECT THE UHD722 TO USE THIS INPUT?
On the set-up program, under the “Audio” tab within “Properties” of the UHD722, the setting “Linear PCM” should be set to “6 Ch. Three digital interconnect leads should be connected between the two units. On the UHD722, the outputs labelled “1/2”, “3/4” and “7/8” should be connected to the “L/R”, “C/LFE” and “SURR” input sockets respectively on the surround controller.
Note it also says that the Linear PCM should be set to 6 Ch.

Hopefully when you make these changes, things will be sorted.

Cheers,
Steve M


#1: 8000s, 5500HC, 8000s, 861v8, 800Dv4, HD621
#2: 6000s, 6000C, 5000s, 6000s, 568.2mm, 598DP, 511
#3: 5500s, 5000C, 5000s, 561, 800v3, 518