Oracle64,

I used the wrong term above. In that you might have two controllers not two masters.

By default most everything is "Auto" Controller and you have to hit a Key Sequence on the Remote while everything is in standby for it to sort out who will be controller (it will choose). I forget the key sequence, it's probably in a manual and the WIKI.

If you set one device manually as controller (or not) you should set them all manually. There should only be ONE controller. I prefer set controller status manually on everything.

Master refers to speaker Master and Master should be the one you connect the Master Cable to from the Preamp. If using DIN or BNC that speaker that is directly connected should be set as Master and the rest slaves. If SpeakerLink it's the Speaker that plugged into the "Master" row. The cabling should match which speaker has the red light on. If it doesn't it may behave weird.

Often the Master Speaker can also be the controller.

The Controller is the device you want to receive IR commands.

You can end up with multiple masters too, which can work if done right, but can also cause problems.

When you mix legacy and SpeakerLink in different combinations it can get even more confusing/complex.


- Fiddler (IMHO)

If you think listening to music is fun, try learning an instrument.
HT: G61RSL, 4x5K, 5.5KHC, 2xSC6000, Transporter, HD621, Philips BDP7501 4K, Tivo, 65" LG OLED 4K C6
Computer: Foobar2000, 5K, Mojo, HiFiMan HE1000 V2