Originally Posted by Shankar
Thank you all for your comments. I would like to explain my reasoning at using 99 as the reference rather than a lower number.

Bear in mind that the SPDIF input into the 8000 is variable.
That is not true for Meridian processors.M processors have always full signal(0dB) on the digital outputs. When the trinnov feeds the M with analogue signals, then this another story. But hopefully your installer selected the digital outputs at the Trinnov.When your trinnov doesnt take out a full digital signal for an setup error maybe, then you will loose resolution. Also all my other speakers are powered, which means they have their own amps and level controls.

By setting the 8000 at 99, I am using its full amplification capacity-this is not true for digital signals- and adjusting the levels of all other speakers to match it. With the 8000 at 99 and with all other speakers to match, my tolerance for SPL is reached at -10dB on the Trinnov.
This SPL level have nothing to say, its just a SPL but not the 0dB level from a digital signal. This means I have 10dB of headroom for a softer recording.

Setting the 8000 at say 89 would mean that I would need to set the Trinnov at 0dB to achieve comparable SPL, -what is wrong to set the trinnov to 0dB ? That is what you have to do not to loose resolution, what you have, when you not feed the 861 with a full signal(0dB)aswhich leaves me with no leeway for softer recordings.

I did fool around with levels starting at 85 in steps all the way to 99 before settling there.

As to whether there will be any clipping, the other speakers are analog, the Trinnov has level meters for each channel and so far I have not been able to spot clipping on any channel. -So take a test Cd with 0dB, check if you have only a digital connection between trinnov and the 861 and turn your (power) amps off so the speakers get no signal. Then you can hook up a soundcard from your PC to the digital output of the 861 and see with a proper sw the level. The "only" problem here is that the 861 generate a MHR signal what i think the soundcard not understand.So you have to o first to change your configfile and instead of 8k you have to insert older -non hires DSP-.That speakers are not MHR compatible so you can select MHR off or on.I know its work, but i see no simpler way. --But it is a valid point and something I will watch out for with some of the more recent pop type recordings.

Thanks a lot
Send me your setup file from the trinnov if you like.


800v3/218/271/8k.2/5k5s smile /5kC/DSP3200/Reviver/
TT-ELP/Graham Slee Revelation/Trinnov Altitude 32/OPPO 205
__Ayon/HB/Shunyata/Miltzow -- power cables,
__Ayon/Jungson/Miltzow --analog, Miltzow-- digital,
__Vortex/WMA ,