Originally Posted by Carl
... On the connection front, you say you have daisy chained the 5000HC. Can you confirm that this is only for the comms lead?

Note: the SPDIF connection should, as outlined in the config program, be connected to the Centre SPDIF output of the processor.
Ah...that's the rub then. blush

I need a longer coax cable to feed it from the G68D then.

That makes sense then...

On the Reviver front... basically I'd need a pair of them for each set/channel of speakers I want to feed from the G68D?

So for my current setup:

1 pair - Fronts (Daisy chain L&R)
1 pair - Center
1 pair - Rear Surrounds (Daisey chain L&R)

If I want to expand the system to side surrounds then I'd need another pair, correct?

CAT6 is so much easier to run...and terminate!


G68D, DSP7000's, DSP5000C (18 bit), DSP420's, MF-1 Projector, Sony XBR-65 4K