I haven't got it working in home run, but I have done some more investigation with my current setup where the G61RSL is controller and the right master DSP5200 is non-controller. I have kept the G61RSL as controller as it is connected to a 598. Maybe I should setup the 5200 as controller and disconnect the 598 just to make sure.
Anyway, this is what I have found out so far...
I reconfigured the speaker settings on my G61RSL for 4 surrounds then tested the comms on each SpeakerLink port by pressing the mute key and looking at the Master and Slave comms line on that port.
The only difference I can see between the port designated as Master in the Config is that port only supplies a signal on the Master comms line; nothing is supplied on the Slave line. All other ports supply both Master comms and Slave comms except the rear master socket, which supplies no comms at all.
So the problem is linked to a single socket on the G61RSL and thus appears to be a problem with that port.
G61RSL comms when Mute is pressed Andy