Hello Ronnie,
There has always been confusion over the power ratings of the amplifiers in
our active and DSP speakers. This stems from the following.
Power figures quoted for domestic power amps are usually quoted into 8 Ohms.
If the amps in the D8Ks were extracted from the speaker and packaged as
regular amps, they could provide 5 x 100W into 8 Ohms simultaneously and
continuously.
However, the figures given in the user-handbook reflect the actual power
that the amps can deliver as part of the DSP8000 design. The 8Ks use tweeter
and a mid-range drive units with impedances of around 6 Ohms.
Each pair of bass drive units represents a 4 Ohm load. These lower-impedance loads mean that the power "increases" to 150W for the bass and we end up with two sets of apparently contradictory figures!
At the risk of introducing a little more confusion, the designer tells me
that the bass amps can actually deal with peaks in excess of 200W.
I hope that this information is helpful.
All the best, Des.
Desmond Ford
Technical Sales
Meridian Audio Ltd.
Huntingdon, England
www.meridian.co.uk