I did have a close look at this back in Feb. I don't remember much now, so I use these threads as a sort of scratch-pad to capture what I'm thinking about. There's certainly no restricting the Intellectual Property! I would have taken measurements on the G68 that I was modifying to see if the 150W suppply fitted. I was keen to have the fitting brackets on the outside of the PSU chassis, instead of on the inside, as its SOOOO much easier to fit the supply. The 150W would have to use slimmer right-angle brackets, that's all. The again, I dont' think there would be ay need to lift it up off the floor, either.
Originally Posted by WelwynNick
And for anyone who wants to get all ambitious and go over the top, I've been looking at the HDCC-150W supply, which is the largest of all in the Condor, PowerOne and Calex ranges. They're not as easy to find as the CP498A, but I noticed one on ebay today, and did a few measurements. The 105W is 362mm long, and fits OK. The 150W is 381mm long, but is also 115mm deep. I reckon it would fit both the G68 & 861.