I am still to get my audition of the MC200 - I was hoping this week but I have been too busy, hopefully next week.

I meant to ask before - the ad for the MC200 mentions

"analogue outputs delivering fixed 2V peak-to-peak or variable output levels"

How do you adjust the output level??

Reason I ask is my current 506.24 puts out too great a signal for my LX83 and it causes overload distortion - to combat this I need to turn Attenuation on the amp for the CD source.
Attenuation lowers the inpit signal and I boost the overall volume

My cousin has said the 506 puts out a slightly higher than 2volt signal so thats what I have attributed to the overload - the input signal being too great.

I am hoping If 2 volts is still too much to lower it so that I dont need to use attenuation on the amp as I know it will be better to control the signal at the source, rather than reduce it in the amp.

Thanks for the help

861v4 LPSU, HD621, Bryston 9BSST
KEF Reference 3 and 2c, 2 X SVS SB13 ULTRA
Audio PC: JPLay, LPSU, JCAT, PPA Studio
Cables XLO Limited, Unlimited Edition and Signature
Sony VW500 Isotek Titan, DIY Mains and Clean Signal Earth Solution