Retyping is a fundamental Meridian thing. It is their equivalent of a factory reset, except that you get some say on what the initial factory defaults are based on your setup, especially speaker configuration.

Its in the user manual under choosing a standard configuration which is in the configuring without computer section.

Based on 5 x dsp33 and 1 D1500, you probably want to start with type '5.1 DDD' then when you are happy, go back on previous advice regarding integrating your second D1500. Once at standard configuration, you can plug in your sources as per standard source settings a couple of pages further on.

As you have a 562v2, it is likely that most of your sources will be on one of the coax digital inputs which does complicate matters slightly as your 562v2 will be doing the source/input switching before it gets to the 568, but the 568 will still need to be setup to remap the physical inputs of each logical source to the single input that the 562 is connected to. As you seem to be struggling, leave the 562 out of the loop for now just until you are happy with the 568.

Then following the speaker calibration steps using your SPL meter.

Once you are happy that all is well, progress to legacy PC config program to fine tune your settings.

Apologies for any errors in above. Its been a long time since I had a 568.



Meridian owner since 1992
Prime & PSU, Focal Elear headphones, Roon (ROCK 8Gi5 NUC), Explorer 1 & 2, F80. 200/203, various Sonos (via Roon).