I believe you want to maximise the digital volume range and minimise the analogue in order to avoid digital distortion from low bit range. This means winding it up on the processor and down on the sensitivity knob, as you describe above.
You can have 7.1 or 5.3 - the maximum number of channels is eight. But the trick you have open to you is to exploit the fact that a DSP sub daisy-chained off a DSP speaker (or another DSP sub) doesn't count as a channel. So a 5.0 system could have two D1500s hanging off the DSP5000s giving deep bass without a .1 channel because the processor will route the .1 bass to the main left and right speakers in a x.0 system (where they are set to large).
The procesor or sub won't recognise that one sub is daisy-chained off another. If the SPL isn't changing have you done the obvious; take the dust cover off and make sure both subs are operating by gently resting a finger on the driver edge? Alternatively, SPL meters can be challenged at low frequencies. The difference between one sub and two daiy-chained together is only 3db which may be on the edge of the SPL meter's resolution at that frequency range.
Last edited by Gianni; 2010-11-09 12:40. Reason: spelling