Just wanted to add that I am running Trifield center eq flat. It has sounded more natural to me since the beginning of listening to it.
I was as well before this.
George, can you please comment my readingsof the measured Trifield EQ curves are correct:
The graph is showing as explained in the text
The 4 top lines are the different EQ�s
top EQ3 then EQ2 then EQ1 and EQ flat.
Then follows the left channel top is direct mode(no center in layout)
and superimposed (same level) the left channel (still no center in layout) in Trifield mode.
So with no center speaker the mains are the same(Trifield or direct DSP mode)
When a center is in the layout and Trifield is selected,
then the highest frequency amplitude down to 8kHz are close the same for the L&R channels.
Then the level slowly start attenuated down to 1kHz and then approximately flat minus -3dB to 20 Hz.
Is that correct?
So when you do the +3dB "boost" on the mains, the are at "real 0 dB" only above 8kHz
and below that frequency you loose down to 3dB.
But that also means that without your +3dB thing(have the mains calibrated to 0dB),
that with Trifield mode enabled, the mains have a "lost" of 6dB !!.
Look at the EQ curves and Trifield selected with +3dB all front speakers calibrated,
then you have a problem with a +3dB saturation on the center when you select EQ flat and EQ1.
But this is only true when your recording have a headroom below 3 dB.
I believe that is extremly rare or happened not practically.
So you can adjust all fronts to +3dB and have no problem at all with EQ flat and EQ1.
With EQ2 and EQ3 you get saturated up to +6dB in some frequency ranges.
Still I think there is no recording with so less headroom,
but it could happen rarely that the DSP get saturated.
So EQ2 and EQ3 CAN have a problem.
Of coarse you can "adjust" the level for the center in the specific DSP presets,
but then you have not the correct level difference as it should be.
But that is only all true when the center makes the same SPL as the L/R speakers.
If the center needs for example a minus 2dB calibration adjustment to have the same SPL as the L/R DSP�s,
then you can still calibrate the center with +3dB.
To keep the correct level differences to the L/R speakers, you have to lower the center in the specific DSP preset over -2dB.
Then you are more save that the center not get saturated and you have guaranteed the correct level differences.
Doing so, you have all the advantages with nearly no disadvantages with the +3dB trick.
And you can do this similar to the rear and sides speakers in the DSP presets-different values of coarse.
You have to keep about the same differences to the fronts as without the +3dB trick.
Only when your center have a number closer to zero(bigger),
you have to take care about saturation of the music under seldom circumstandes.
What do you mean George-correct ?
Robert