Originally Posted by Steve Eyles
Originally Posted by George Mills
I think Analog may always be full scale to DAC. But like you said you might be dialing in a sweet spot in the preamp or the "Hybrid" implemenation.

I'd guess that it isn't because the processor would control any level differences (between loudspeakers) in the DSP, not at the analogue stage.

I'm not sure how the analogue levels are attenuated in the processors, a hybrid could take the form of reducing the volume in the digital domain from 0dB to -5.5dB in 0.5dB steps, once -6dB is reached (a whole bit) the digital volume reverts back to 0dB and -6dB is applied at the analogue stage.

This would maintain good resolution (for the DACs), good accuracy of volume steps and easy to implement -6dB steps in the analogue stage (-6dB is 50%).

Pure conjecture though.

Steve.

I thought of a way to test this! Using a 518 connected to the 568 digital output while in analog output mode. Use the 518 to monitor digital full scale (it has a clipping indicator). I have an RCA test disk with full scale test tones. I can monitor the digital output as I change volume on the 568 and see how the digital output behaves. I can use the gain on the 518 to see what the offset is as I change volume. I'll just turn my amplifiers off and test away.

Ron


HT: 568.2mm (Revelation One filter), 518x2, SB3, Bryston 7BSTx3, 8BST, Aerial 10T, CC3, SW12(Qty2) w/SVS AS-EQ1, MK Tripole x4. JVC RS1u, DVDO Duo, Oppo 103 w/Vanity103HD, Sony PS3, VIP 3D Theatre, Acer H5360. Logitech Ultimate Remote and Hub.