It could all be done with the current hardware. It's just a DSP firmware change to allow for 1) Channel Ident 2) Channel Calibration Offset and a Processor firmware change to send the commands to the DSPs.

Processor would then broadcast the "CO" command for each speaker when the system is comes out of standby and say when the volume is changed.

CO103.5 Channel 1 (Front Left) -3.5db attenuation
CO203.5 Channel 2 (Front Right) -3.5db attenuation
CO203.0 Channel 3 (Front Centre) -3.0db attenuation
CO202.0 Channel 4 (Front Sub) -2.0db attenuation
CO204.0 Channel 5 (Rear Left) -4.0db attenuation
CO204.5 Channel 6 (Rear Right) -4.5db attenuation
VN65 Volume Number at 65 (Master volume as displayed)

Simple.

Regards,
Carl


861v6+ID40, HD621, 8000.2, 7200HC, 7200.2, SKYQ Silver, PS3, PDP-LX6090, QNAP TS870-Pro (8*6TB), Roon, iPadAir2.
[In Reserve] C15, MD600 (2*3TB), TwinStore RM (2*2TB)