Originally Posted by Ronomy
Also if the volume and speaker trim output is after internal processing as I believe it is the volume is probably in a 24 bit format for the analog DAC's and the DSP speakers (DSP's set to full output of course) and in an analog setup once my volume control hits digital full scale the analog volume takes over. Trims set to -5 is not a problem for analog. I am sure below a certain digital volume analog kicks in again. The -4 or -5 setting I use is probably a sweet spot or something in the processing is adding some compression. probably in the volume control in the processor. This doesn't get used in the case of the DSP speaker setups. DSP speaker volume in in the speakers.

You guys seem to think you are changing input bit depth but I don't think you are changing it with the trims. You are changing input bit depth to the DSP speakers but that is after processing of Trifield and any other 48 bit processing! The processor is always seeing full scale input if the recording is full scale. If not that's when a 518 is useful.

Ron

Read all my posts.

G68 is doing exactly what 518 is doing. Except you were locked into -3dB plus what ever you subtract for calibration. Using the tweak you are no longer locked into -3dB.

I measured it. It's full scale in and -3dB out (when calibrated to 0dB).

Doesn't matter how many bits is used internally in G68 or DSP Speaker. Folks keep thinking that somehow solves the problem. It doesn't. You've pushed your data down and that's not always good. If anything you may want to push it up if something is recorded low (As you said). If something is recorded too loud (i.e. clipped) there is nothing you can really do. Attenuating won't help it, that most signifcant data is lost if it was recorded too high. If it was recorded too low you've lost LSB bits which isn't nearly as bad. But by raising it you're sliding it into the better performing part of DAC.

You can treat the DSP speaker like any other DAC. Except you can't TRIM them in analog. That's what I'd like to see implemented in DSP firmware. Just like MI did on his "thirdparty DSP" setup. Setting all front to +3dB and compromizing other channels is the closest as we can get (which isn't that bad).


- Fiddler (IMHO)

If you think listening to music is fun, try learning an instrument.
HT: G61RSL, 4x5K, 5.5KHC, 2xSC6000, Transporter, HD621, Philips BDP7501 4K, Tivo, 65" LG OLED 4K C6
Computer: Foobar2000, 5K, Mojo, HiFiMan HE1000 V2