Originally Posted by Steve Eyles
I've just done some listening tests on my all analogue set-up (568.1)

I did -3dB, 0dB and +3dB for the main L & R. (spl corrected)
I did this several times on the same tracks.
The differences a small to say the least, but overall if I had to put them in order it would be;

1st -3dB
2nd 3dB
3rd 0dB

The -3dB just sounds a little more open and individual sounds are easier to make out.

The differences aren't night and day by any means, very very subtle to the point of not being valid due to expectation bias.

This may not be an issue at all with a 568.1 using the analogue outputs.
But then again Trifield width still works on the 568.1...

Steve.

I had the 568.1 before I got my 568.2 and this is where I first started using -3db. -3db was the best on that processor. Below that the bass became less tight but my setup and room was completely different back then. I had different amplifiers and subs. It wasn't as transparent as my system is today. Back then it just sounded more dynamic to my ears.

Ron


HT: 568.2mm (Revelation One filter), 518x2, SB3, Bryston 7BSTx3, 8BST, Aerial 10T, CC3, SW12(Qty2) w/SVS AS-EQ1, MK Tripole x4. JVC RS1u, DVDO Duo, Oppo 103 w/Vanity103HD, Sony PS3, VIP 3D Theatre, Acer H5360. Logitech Ultimate Remote and Hub.