OK...so, I have had a fairly limited listen this afternoon/evening.

Initial feeling is that it is very much like plugging a digital source directly into the DSP's. I've always found a difference doing this back to the 568's I've had.

I sourced direct to DSP a while back when I had SB3 into G68 and 8k's using both D1 and D2 inputs. There was quite a difference then and whilst I liked the raw presentation of the SB3 into DSP I felt I missed the MRC more. When I moved to SB+ I just used G68 route as the SB+ optical is disabled (i.e. couldn't run two routes).

The Sb+ now into G68+3dB seems to give the best of both worlds in that I get MRC included.

Presentation seems brighter. More detail (as others have noted). Voices are really quite excellent and the treble is sweeter and more distinct. I sense that it's all a little more dynamic but haven't had chance to go back to the standard profile at 0dB.

FWIW - my front 3 were all set at 0dB originally.

I've just pumped up some tunes to about 65 and they are pumping out. It sounds quite different. Not sure if some control is missing. I'm going to reserve judgement on the long-term listener fatigue aspect of the system.
I may get some time tmrrw to test this some more.

Is it a design choice (that we might someday understand), an oversight (M say they actually use listening tests rather than specs to finalise a setup/design) or potential user adjustable parameter ? It would be very interesting to see what M find when they do this.

I don't know. I'll spend more time listening and will swap back and see what happens.

I'm not sure where in the logic we get to know that it's 100% 3dB down on full digital 0dB. Is this just empirically deduced via the spl measurements ?

Well done again George.

Cheers

N


Rgds,
Nick