|
President of the Imperial Galactic Government
Joined: May 2000
Posts: 8,364 Likes: 14 |
It was only a joke about 97. In fact Max Volume (in the DSP speaker) is completely independent. You can have digital clipping at any volume.
After putting this tweak in place I got rid of the -3dB on the center in Trifield so that it could be "LevelPerfect" on the center too. I may change it back, but I wanted to try it. So far I like it. I think the added clarity on the Center made the need for -3dB less critical. My front 3 are +3db in calibration and no center attenuation in Trifield. This is only possible if front 3 are reasonably close to begin with.
Another way to do it is put 0x26 for Front Left / Right in MSL. Down load that to G68 and measure level of front Left/Right with an SPL meter (use average of two if they differ any and that as a target level for other channels).
Now keep adjusting all other channels (boosting hex values (by small amounts -e.g. 2 steps say) downloading and testing) until they match the level on front left right. You'll understand the numbers better once you go through trial and error. In the end you should check with meter anyway. Mine all measure 82dB now instead of 75dB.
If you want to keep your center -3dB (in Trifield) you can but I don't believe it will get the benefit of the "tweak". That's a personal choice. It depends on how important you think this tweak is and what you think the cost is of not doing it.
I forgot if you set all other channels (Except subs as Frank discovered) to 0x21 (+0.5dB) and you can use the G68 built in calibration and adjust it until it matches mains. Once you cross 0.0db you can't go back though. Then you can fetch G68 config and save to temp file to see what the hex values are.
If folks decide to compromise levels a bit to get exactly "LevelPerfect" don't let this change in relative levels fool you into thinking it's better or worse. My center was only off by 0.5dB from mains. So I could get away with getting center at +3dB too pretty easily. I compromised center being off +0.5dB. When I remeasured everything it was pretty darn close to equals so I'm not concerned.
Also if you want to compare apples to apples. Listen in Direct mode before making any changes, get familiar with a tune(s). Then make the change just on Left/Right to 0x26 and then listen in Direct again. If you like what your hearing then do the rest. If you don't put it back.
To do the rest just add the same difference you had to add to get mains up to +3dB. If your mains were -2.0dB you have to add 10 to the Hex Value (10 0.5dB steps is +5.0dB) to get to +3.0dB. So add 10 to the hex value of all other channels. Open in MConfig, check if it makes sense. Then download and measure with a meter that they all read the same level. Or close to same level if you compromised a little to reach exactly 3.0dB.
My guess is, if it's not EXACTLY 0x26 there is no benifit to that channel. I don't think it gradually gets better as you approach +3.0dB. But I could be wrong on that.
Also be sure to start with a copy of your original config in case you goof up editing or decide this tweak is not for you.
- Fiddler (IMHO)
If you think listening to music is fun, try learning an instrument. HT: G61RSL, 4x5K, 5.5KHC, 2xSC6000, Transporter, HD621, Philips BDP7501 4K, Tivo, 65" LG OLED 4K C6 Computer: Foobar2000, 5K, Mojo, HiFiMan HE1000 V2
|