|
President of the Imperial Galactic Government
Joined: May 2000
Posts: 8,364 Likes: 14 |
Hey I just noticed you can adjust the calibration levels even on the positive side from the Front panel of G68. I can go up or down. Until I hit 0.0 then it won't allow crossing 0.0 back to the positive side again.
Someone must have an If == 0 instead >= 0 do not past go.
I wanted verify if this was possibly a Mconfig bug and see if the firmware enforces it. It does but it's enforcement is weak.
- Fiddler (IMHO)
If you think listening to music is fun, try learning an instrument. HT: G61RSL, 4x5K, 5.5KHC, 2xSC6000, Transporter, HD621, Philips BDP7501 4K, Tivo, 65" LG OLED 4K C6 Computer: Foobar2000, 5K, Mojo, HiFiMan HE1000 V2
|