Originally Posted by JimboMeridian
I have to thank Crion for mentioning the Dune BD Prime 3.0.
I didnt even know it existed!

..

Next stage will be to get the power supply and digital board upgraded on the Dune. Maybe a superclock. I think there are several companies who upgrade stock players.

I would only do old-school mods on it, screwing around with the clocks is not always the golden ticket. Changing PSU should be straightforward for people used to modding the Oppo BD83 for example as they have similar hardware layout in the chassi and probably need similar voltage. I've made two small mods on mine. Now, it sounded fine before these mods and it still sounds fine after so Success! laugh

Now I wouldn't recommend these to anyone, it's probably better to keep your warranty! Now with that out of the way, this is the damage I did:

Dune mods:
Furutech FI-09 Rodium IEC inlet (Yes, sawing out the old one!)
Furutech Fuse 1,6A 5x20mm (just replacing the stock one on the PSU)

DIY Powercord:
Furutech FI-50 IEC
Furutech FI-E50 Schuko
Furutech FP-3TS762 Shielded powercord

If there was/is a difference I would probably tribute more of it to the shielded powercord than fiddling around in the Dune.



DSP8000SE, DSP7200SEHC, DSP5200SE sides, DSP7200SE rears, 861v8, 210, Sim2 Ultranero 4, Stewart Cinecurve 2.35:1, XEIT CM-5E Anamorphic lens, Dune HD Duo Cinema 8K and Wireworld Platinum 48G HDMI -> UHD722 -> Shunyata Omega Ethernet. Shunyata/Furutech power-cables/filters. SR Master Fuse@861v8. Uptone Etherregen with 10MHz OCXO clock.