Nick, I've been thinking about this a lot recently.

Although crion has a lot more experience with multiple subwoofers than I do, I'm going to disagree with him about chaining the subs together on the grounds that Meridian feels that a stereo bass image is important, even for subs. The 568.2MM can handle a "discrete" 5.2 setup (as opposed to a 5.1 with a double sub).

As you say, you have two options:

You can use each D1500 to turn your main L/R DSP33s into "full-range" speakers in a 5.0 setup, but there is a problem here which isn't obvious. The D1500 crossover switch in the "FILTER2" position selects a 56Hz low-pass filter "optimized for use with DSP33s". The issue I have with this is that there is no corresponding "56Hz" high-pass filter on the DSP33s:

a) I'm sure that Meridian chose 56Hz on the D1500 to match the bass response of the DSP33s as accurately as possible. However, I doubt that the 2nd order Butterworth filter in the D1500 is a exact match for the bass drop-off in the DSP33s. Assuming you correctly set the sub volume to integrate with its corresponding DSP33, it's not the most controlled crossover.

b) Worse, remember that DSP33 bass extension is extended at low and moderate volumes? At which volume does the 56Hz D1500 crossover work best with the DSP33s? Without a corresponding high-pass crossover in the DSP33s, the implications of melding a static crossover in the sub with volume-varying bass response in the DSP33s can only be volume-dependent bumps in the bass response around 40-60Hz. I discussed this with Des Ford several years ago and asked him if Meridian had a graph showing how the DSP33 bass extension changed with volume. However, such a graph ever existed, it got lost in the mists of time and would only have been of use for satisfying my curiosity.

Having discounting option one, I think you should use the stereo subwoofer outputs and crossover in your 568.2. This will yield a far more accurate, precise and coherent crossover between the DSP33s and subs. For what it's worth, I have a single REL sub to which I crossover bass from my 5x DSP33s at 56Hz with my G68. It sounds good at the moment, though 56Hz may be a bit too low. To do better, I need to investigate what is going on in the crossover region with an RTA analysis tool. This is something that I plan to do later this year.


Roon Developer and ex-moderator of this Forum
I am #25 in the HH1 photo of fame.