And a further thought regarding the EIGHT by Speakerlink out on the 861.............
My original thought was that you would have the following at the back of your 861 (in a situation where you had SPDIF plus Comms Cables running from the back of your 861 out to each of the DSP pairs. Again, by far the most common current Meridian DSP Installation)
a) ONE off Speakerlink output to a Powered AC12, which would convert Speakerlink into SPDIF and Comms
b) You would connect your EXISTING SPDIF + Comms cable to the AC12 Output ports
c) Your Cables would then run as normal to each of the DSP Pairs
However, if there are really EIGHT by Speakerlink Outputs on the 861v6, does this mean that you would have TWO Speakerlink Inputs into each AC12, which would then convert that to ONE SPDIF + Comms???
My brain is beginning to hurt..............
Last edited by Ronnie Hurley; 2010-01-22 15:05.